Saw Holder T-Shank Blade Scalpel for the Leatherman Free P2 P4 Series
Scalpel Blade Bit Holders Saw T-Shank for the Leatherman Free P2 P4 Series
T-Shank Saw Holder:
Made of 304 stainless steel
Thickness 2.5mm,Can replace the original saw position
Suitable for Bosch T118 series
Saw blade thickness 1-1.2mm are compatible
It is recommended to remove the original 3 thin washers during installation to ensure uniform thickness. (The rear washers on both sides of the pliers must be retained)
The saw blade needs to be in the non-locking position when installing and removing
22# Scalpel Holders:
Made of 304 stainless steel Thickness 2.5mm
Compatible with 21-36# scalpels of different shapes (this kind of scalpel is thinner)
60# Scalpel Holders:
Made of 304 stainless steel Thickness 2.5mm
The thickness of the scalpel is 0.5-0.6 mm very strong
Flat & 4mm & 6.35mm
Bit Holders
Made of 440C stainless steel Thickness 6.35mm or 8mm 58HRC
Used to replace the original 4 small drill bits
can also replace the original 2 large drill bits
Adjust their smoothness with washers
Both P2 and P4 can be installed and used
They are held in place by magnets inside
and they both support 3 shapes of screwdrivers that you can choose according to your preference
They are all made of stainless steel by wire cutting, and they are all very strong(not 3D printing)
Type C: Bit Holders use 420 stainless steel, more magnetic (disadvantage is that it may rust if not maintained in wet environments)